FAQG7111L
Frigidaire Affinity FAQG7111L Dryer Repair
Most common issues on this model
- Gas dryer that runs but dries slowly
- Heat that cuts out at the end of a long vent run
- Noisy blower or a rattle in the rear
- Control that stops responding after a power flicker
The FAQG7111L is a Classic White Affinity gas dryer with a 7.0 cubic foot drum, and FAQG7111LW is its sibling label. It is an older model that remains in many Houston homes, and we repair it where the repair is sensible.
Slow drying with a gas dryer usually combines two issues: weaker heat and poor airflow. We test the burner flame and the venting at the same visit. A rattle at the back may come from lint on the blower wheel or a loose wheel on its shaft. After a power flicker, a control that no longer responds calls for a check of the connectors and the board.
With the label number and serial in hand, we can order the right igniter, valve or blower part. You approve a written estimate, and the work is guaranteed for 30 days.
Key features
- Affinity gas dryer
- 7.0 cu. ft. capacity
- Classic White finish
- Also sold as FAQG7111LW
Error codes this model can show
Why is my gas dryer slow to dry?
Reduced flame, a clogged vent or both. We look at the burner, measure airflow at the outside wall and clear lint from the duct before suggesting a part.
What makes the rear of the dryer rattle?
Lint on the blower wheel or a loose wheel are the usual causes. We remove the housing, clean the wheel and check that it is tight on the shaft.
Can a power flicker damage the control?
It can, but a loose connector is more common. We check the harness first, then test the board, and tell you the price of each path.
Book repair for your FAQG7111L
Book online in about a minute, or give us a call. Same-day appointments are available inside the Loop on most days, and next-day service across the rest of Houston.