Error code · Washer

Frigidaire Front-Load Washer Code EB3: Line Voltage Under 90 Volts

Medium · inspection needed

Code: EB3
Appliance: Washer
Brand: Frigidaire
Warranty: 30-day workmanship

What EB3 means

EB3 is the opposite of EB2: it means the incoming line voltage is below 90 volts AC. The code applies to Frigidaire front-load washers with the horizontal-axis electronic control, including the 3.0 cu ft Frigidaire and Gallery washers and the Affinity 6000 and 7000. A washer cannot run its motor properly on weak power, so the control stops the cycle. Owners often see it when the lights dim, on a long extension cord or on a heavily loaded circuit. The first check is the voltage at the outlet.

Common causes of EB3

Weak voltage at the outlet
Extension cord or worn outlet
Heavily loaded circuit shared with other appliances
Control board reading the supply wrongly

✓ One safe check you can try

1. Plug the washer directly into a wall outlet without an extension cord. 2. Turn off other large appliances on the same circuit and try again. 3. Have the voltage at the outlet checked. 4. If the outlet is normal and EB3 returns, call us.

! Why to stop there

Low voltage can come from the home's wiring, the outlet or the washer's own reading.
We check the outlet voltage first, then the washer, and tell you what we find before a price is agreed.
If the wiring in the home needs work, we tell you that rather than replace washer parts.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

F2Frigidaire Washer Code F2: Too Much or Wrong Soap LED flash-count codes (non-display models)Frigidaire Gallery Washer Without a Display: Reading Codes from Blinking Lights LOCFrigidaire Front-Load Washer Display LOC: Control Lock Is on ErrFrigidaire Affinity Washer Display Err: A Stored Error Needs Reading E98Frigidaire Affinity Washer Code E98: Panel Circuit Problem Detected EBEFrigidaire Affinity Washer Code EBE: Console Control Flag EBFFrigidaire Affinity Washer Code EBF: Console Control Warning EB1Frigidaire Front-Load Washer Code EB1: Power Frequency Out of Range

EB3EB3 questions

What causes low voltage at an outlet?

Common causes are a long extension cord, a worn outlet or a circuit shared with other large appliances. We check which applies. A long extension cord, a worn outlet or a shared circuit are the usual suspects, and we check which one applies.

Is EB3 the same as a tripped breaker?

No. A tripped breaker removes power completely. EB3 means power is present but too weak. A breaker that has tripped cuts power completely, whereas EB3 means some power is present but too weak.

Can I keep using the washer?

We would not run it until the outlet is checked. Weak power is hard on the motor. Weak power is hard on the motor, so we suggest waiting until the outlet has been checked.

Book a visit

Still seeing EB3?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 844-8518