Error code · Washer

Frigidaire Affinity Washer Codes E93 and E94: Console Board Reports a Problem

E93 and E94 are a matched pair of console control codes on the Frigidaire Affinity 6000 and 7000 front-load washers, both the 2006 generation and the 3.5 cu ft washers of about 2009 to 2012. Each…

Medium · inspection needed

(713) 844-8518

Code: E93 / E94
Appliance: Washer
Brand: Frigidaire
Warranty: 30-day workmanship

What E93 / E94 means

E93 and E94 are a matched pair of console control codes on the Frigidaire Affinity 6000 and 7000 front-load washers, both the 2006 generation and the 3.5 cu ft washers of about 2009 to 2012. Each says the washer found a problem in the console, the panel that holds the keys, the knob and the display. You may see a washer that ignores the keys, will not begin a cycle or stops with E93 or E94 showing. The code points to the panel circuit and does not single out one part.

Common causes of E93 / E94

Console board or processor not responding correctly
Connector or harness between the console and the main board
Keys or selector contacts on the panel

✓ One safe check you can try

1. Turn the washer off and on again. 2. Dry the panel and make sure nothing is spilled on it. 3. Try a basic cycle once. 4. Should either code come back, leave the washer off and call us. 5. If either code returns, stop using the washer and call us. A quick note of which code shows helps us bring the right part.

! Why to stop there

Both codes point to the console circuit, and neither names the part.
We check the connections and the console board, then give you a written price before replacing anything.
On an older washer we say plainly if a new console is not worth the cost.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

F2Frigidaire Washer Code F2: Too Much or Wrong Soap LED flash-count codes (non-display models)Frigidaire Gallery Washer Without a Display: Reading Codes from Blinking Lights LOCFrigidaire Front-Load Washer Display LOC: Control Lock Is on E98Frigidaire Affinity Washer Code E98: Panel Circuit Problem Detected EBEFrigidaire Affinity Washer Code EBE: Console Control Flag EBFFrigidaire Affinity Washer Code EBF: Console Control Warning EB1Frigidaire Front-Load Washer Code EB1: Power Frequency Out of Range EB2Frigidaire Front-Load Washer Code EB2: Line Voltage Above 130 Volts

E93 / E94E93 / E94 questions

Why are E93 and E94 listed together?

They belong to the same console control group in the Affinity charts. We handle them the same way, testing the panel, the connection and the board.

Could the main board be the problem instead?

It is possible. The console and the main board talk to each other, so we test both ends before we decide. Our checks cover both the panel and the main board, since they talk to each other all the time.

Will my cycle settings be lost?

They may reset when the washer is turned off. We help you set the cycle again after the repair. We help you set the cycle again after the repair, and the repair carries a 30-day warranty.

Book a visit

Still seeing E93 / E94?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 844-8518