Error code · Washer

Frigidaire Affinity Washer Code E98: Panel Circuit Problem Detected

Medium · inspection needed

Code: E98
Appliance: Washer
Brand: Frigidaire
Warranty: 30-day workmanship

What E98 means

Frigidaire Affinity 6000 and 7000 front-load washers show E98 when the control detects a console control problem. It is listed for the 2006 washers and the 3.5 cu ft washers of about 2009 to 2012, and it is not in the earlier 3.0 cu ft chart. It is one of a group of codes that point to the control panel, the part you press and turn. Owners usually see the display stuck on E98, a cycle that will not begin or a washer that behaves oddly after a power change.

Common causes of E98

Control panel board
Connector between the panel and the main board
Selector or key pad

✓ One safe check you can try

1. Turn the washer off and wait a moment before turning it back on. 2. Press Start on a short cycle and watch the display. 3. Keep the panel clean and dry. 4. If E98 appears again, call us. 5. Keep a note of when E98 shows, such as at power-up or mid-cycle, and tell us when you call.

! Why to stop there

The code points at the panel circuit without naming a part.
We check the panel, its connection and the main board in order, and give you a written price before replacing anything.
If the cost is close to a newer washer, we tell you.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

F2Frigidaire Washer Code F2: Too Much or Wrong Soap LED flash-count codes (non-display models)Frigidaire Gallery Washer Without a Display: Reading Codes from Blinking Lights LOCFrigidaire Front-Load Washer Display LOC: Control Lock Is on EBEFrigidaire Affinity Washer Code EBE: Console Control Flag EBFFrigidaire Affinity Washer Code EBF: Console Control Warning EB1Frigidaire Front-Load Washer Code EB1: Power Frequency Out of Range EB2Frigidaire Front-Load Washer Code EB2: Line Voltage Above 130 Volts EB3Frigidaire Front-Load Washer Code EB3: Line Voltage Under 90 Volts

E98E98 questions

Is E98 a serious problem?

It is a control problem, not a flood or heat problem. It still needs testing, because the washer may not run reliably. A washer showing E98 can still be affected by a loose connector or a worn key, so we check each one in turn.

Is E98 the same as E97?

They sit in the same console group and we test them the same careful way. The exact cause can differ. The cause can still differ between the two, and we find it by testing the panel and the board, not by guessing from the code.

How long does the repair take?

It depends on whether we find a loose connection or a failed board. We confirm in writing before any work. We confirm the price in writing before any work, and the repair carries a 30-day warranty.

Book a visit

Still seeing E98?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 844-8518