Error code · Dehumidifier

Frigidaire FHDP5033W1 Dehumidifier Codes EH60 and EH61: The Sensor Needs Testing

Medium · inspection needed

Code: EH60 / EH61
Appliance: Dehumidifier
Brand: Frigidaire
Warranty: 30-day workmanship

What EH60 / EH61 means

On Frigidaire Gallery and high-efficiency pump dehumidifiers in the FHDP5033W1 family, EH60 and EH61 mean a sensor has failed. The control uses its sensors to judge room conditions, so with either code showing the unit may stop dehumidifying or run without control. These codes tell us a sensor reading is missing, and the sensor itself, its wiring or the board input must be tested to know which.

Common causes of EH60 / EH61

A sensor that has failed or come loose
The sensor wiring or plug
The board circuit behind the sensor

✓ One safe check you can try

1. Unplug the unit and wait a minute. 2. Plug it back in and check the display. 3. Clean the air filter and clear the intake. 4. If EH60 or EH61 comes back, book a visit. 5. Do not run the unit unattended while the code is showing, and keep the bucket seated and upright.

! Why to stop there

A reset cannot repair a sensor, so a returning code needs testing.
We check the sensor and its connection first, then the board.
Written pricing comes before work, and we will tell you if an older unit is not worth repairing.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dehumidifier codes

F0Frigidaire Dehumidifier Code F0: Cooling Circuit Is Not Working F1 or F2Frigidaire Dehumidifier Codes F1 and F2: Sensor Failure with a Dead Reading FilterFrigidaire Dehumidifier Filter Light: Cleaning Reminder at 250 Hours H3 or E5Frigidaire Dehumidifier Codes H3 and E5: Compressor Overload Protection L1 or F5Frigidaire Dehumidifier Codes L1 and F5: The Humidity Sensor Lost Its Reading LCFrigidaire FHDD5034Y1 Dehumidifier Code LC: Control Lock Turned on PUFrigidaire Pump Dehumidifier Code PU: Bucket Not Pumping Out Pump + Bucket Full indicators flashingFrigidaire FFAP5034W1 Dehumidifier Pump and Bucket Full Lights Flashing: Hose Check

EH60 / EH61EH60 / EH61 questions

Why does my display show EH60 or EH61?

Each one reports that a sensor has failed. The unit cannot read the conditions it needs, so it may not dehumidify correctly until the sensor is repaired or replaced.

Can I keep using the unit?

We recommend turning it off until it is checked. Without a working sensor, the unit may run endlessly or stop too soon and the bucket or coil can be affected.

Will the repair be expensive?

Sensor repairs are often modest. We confirm the cause, give you the price in writing, and you decide before we start any work. Replacing a failed sensor is a routine repair on these units.

Book a visit

Still seeing EH60 / EH61?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 844-8518