Error code · Microwave

Frigidaire Convection Microwave Stops with E-26 When Heat Falls Short

Medium · inspection needed

Code: E-26
Appliance: Microwave
Brand: Frigidaire
Warranty: 30-day workmanship

What E-26 means

E-26 on Frigidaire convection microwaves, such as FPMO209KF, means the microwave failed to reach the designated temperature. It is related to E-03 and E-23, but E-26 is the general message that the set temperature was not reached. The oven side is not heating as the control expects, and you see the code and a stopped cycle. The handbook does not name which individual models carry this code, so we confirm your exact model on the visit.

Common causes of E-26

The convection heater
The oven thermal sensor
Airflow in the cavity
The control board

✓ One safe check you can try

1. Wait for the microwave to cool with the door ajar. 2. Check that the vents are clear. 3. Try a plain microwave cycle. 4. Try a lower oven temperature. 5. If the code comes back, we can schedule a visit. 6. Do not run convection again until it has been checked, and note which mode was running.

! Why to stop there

The code says the temperature was not reached, not why.
We test the heater, the sensor and the board in turn.
If the microwave is too old to justify the repair, we will tell you.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Microwave codes

E-03Frigidaire Convection Microwave Code E-03: Slow to Reach Temperature E-11 / E-12Frigidaire Convection Microwave Codes E-11 and E-12: Gas Sensor E-13Frigidaire Convection Microwave E-13: Sensor Cook Timed Out E-21 / E-22Frigidaire Convection Microwave Codes E-21 and E-22: Oven Thermal Sensor E-23E-23 on a Frigidaire Convection Microwave: Preheat Took Too Long E-24Frigidaire Convection Microwave Overheat Code E-24 ERRORFrigidaire Sensor-Cook Microwave Message ERROR F3Frigidaire Convection Microwave Showing F3 for a Key Short

E-26E-26 questions

How is E-26 different from E-03?

E-03 is a three-minute check on warm, convection, preheat or broil. E-26 is the general message that the designated temperature was not reached. E-26 is the broad message that the target was not reached, while E-03 and E-23 are more specific timing checks.

Will the microwave still work as a microwave?

Often yes. The code is about oven heating. They point to the same side of the microwave. Tell us which mode and temperature you set when the code appeared, because that tells us where to start testing.

Can you repair this?

Yes. We repair convection microwaves and quote the price in writing first. We check the heater and sensor. If E-26 appears together with E-03 or E-23, say so, since that points to the same heating side.

Book a visit

Still seeing E-26?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 844-8518